EnoughToBuy Guides

Outdoor

How Many Rolls of Sod Do You Need for a Yard?

By the EnoughToBuy teamUpdated November 15, 20266 min readSources and assumptions

Quick answer: A 40 ft × 25 ft yard is 1,000 ft². With 5% extra for cuts, it takes 105 sod rolls if each roll covers 10 ft². Check your roll size first: the count is the area divided by what one roll covers.

Buying sod is a counting job. You measure the ground, add a little for cuts, and divide by what one roll covers. The figures on this page come from the sod and grass seed calculator, so you can type your own yard size and roll size and see the count change.

One thing to keep in mind: the roll size is an input, not something the calculator knows about your supplier. It starts at 10 ft² per roll because that is the common 2 ft by 5 ft roll named in its source, but your supplier may cut rolls differently. Every table below says which roll size it uses.

Try itSod or grass seed: enter your own sizes
You would buy105rolls
  • Sod rolls (10 ft² each)105 rolls
Open the full calculator with more options

Sod rolls for a 40 × 25 ft yard at a glance

This is the shopping list for the yard in the quick answer, with 10 ft² rolls.

ItemAmountHow it is worked out
Lawn area1,000 ft²40 ft × 25 ft
Area with waste1,050 ft²1,000 ft² × 1.05
Sod rolls1051,050 ft² ÷ 10 ft² per roll, rounded up

Starter fertilizer, topsoil and a roller are not in the count. The calculator lists them as things to think about, since they depend on your ground.

40 ft 25 ft Rolls of 10 ft², rows staggered
The 40 ft by 25 ft yard from above, with 10 ft² rolls laid in staggered rows.

How to calculate sod rolls, step by step

  1. Measure the length and width. Use the longest and shortest straight runs of the area: 40 ft and 25 ft.
  2. Find the area. 40 × 25 = 1,000 ft².
  3. Add the waste allowance. The calculator adds 5% for cuts around edges and curves: 1,000 × 1.05 = 1,050 ft².
  4. Divide by the coverage of one roll. 1,050 ÷ 10 = 105.
  5. Round up. You cannot buy part of a roll, so the answer is 105 rolls.

A quick check for any yard: with 10 ft² rolls and 5% waste, every 100 ft² of lawn works out to 10.5 rolls before rounding. Multiply by your area ÷ 100 and round up at the end.

Sod rolls by yard size

The same method for a range of yards, with 10 ft² rolls and 5% waste.

YardArea (ft²)Sod rolls
20 × 15 ft30032
25 × 20 ft50053
30 × 30 ft90095
40 × 25 ft1,000105
50 × 40 ft2,000210
60 × 50 ft3,000315
100 × 50 ft5,000525

The roll count tracks the area closely, since each roll covers the same amount. If your yard falls between two rows, use the calculator with your own length and width.

What if your rolls cover a different area

The 10 ft² roll is a starting value. Some suppliers may sell larger or smaller pieces, so read the roll size from the product listing or ask. This table keeps the 40 × 25 ft yard and 5% waste and changes only the coverage of one roll.

Coverage per roll (what-if)Sod rolls
5 ft²210
8 ft²132
10 ft²105
12.5 ft²84
16 ft²66

Smaller rolls mean more of them, with more seams to lay. Larger rolls mean fewer pieces, but each one is bigger to carry and cut. The calculator treats every roll as a perfect rectangle that covers exactly the number you type.

Yards that are not a rectangle

Most yards are not a clean rectangle. Split the lawn into rectangles, add their areas, and run the total once. Rounding each piece separately can leave you buying more rolls than the whole yard needs.

Here is an L-shaped yard made of a 30 × 20 ft rectangle and a 15 × 10 ft rectangle.

PieceArea (ft²)
30 × 20 ft600
15 × 10 ft150
Total750

750 ft² with 5% waste and 10 ft² rolls comes to 79 rolls. In the calculator, type the total area as the length and 1 as the width to get the same answer.

For a bed, a patio or a tree ring inside the lawn, subtract it. If a 10 × 8 ft bed sits inside the 40 × 25 ft yard, the lawn area is 1,000 − 80 = 920 ft², which needs 97 rolls instead of 105.

How much waste to add

The calculator adds 5% for cuts. That is a contractor rule of thumb, not a measured figure, and you can change it. This table keeps the 40 × 25 ft yard and 10 ft² rolls.

Waste allowanceArea with waste (ft²)Sod rolls
0%1,000100
5%1,050105
10%1,100110
15%1,150115

With no waste at all you would buy 100 rolls. Curved edges, many corners and cuts around trees all use more sod than a plain rectangle does. For help picking a percentage, read how much waste factor to add to building materials.

Before you order

Sod is living grass, so timing matters more than it does for lumber or concrete. Ask your supplier how soon the sod needs to be laid after it is cut and delivered, and have the ground ready before it arrives. If you are still deciding what goes under the lawn, the guide on topsoil for a new lawn covers the soil layer. If you are weighing sod against seed, see sod vs grass seed.

Measure the yard yourself rather than trusting a plot map, since a house, a patio or a driveway edge may sit a little differently than on paper. The guide on how to measure for materials works for any rectangle, indoors or out.

Common mistakes when buying sod

  1. Assuming every roll covers 10 ft². Check the size on your supplier's listing. At 5 ft² per roll the same yard needs 210 rolls, not 105.
  2. Skipping the waste allowance. Without it the count is 100. One cut that goes wrong and you are short.
  3. Rounding each rectangle separately. Add the areas first, then round once.
  4. Counting the beds and patio. Subtract any area that will not be lawn.
  5. Measuring the wrong surface on a slope. The calculator works from a flat length and width, so measure the surface you will actually cover.
  6. Ordering before the ground is ready. Living sod does not wait well. Prepare the soil first.

Frequently asked questions

How many rolls of sod do I need for 1,000 square feet?

With 10 ft² rolls and 5% waste, 1,000 ft² takes 105 rolls. Without the waste allowance it is 100.

How many rolls of sod are in 100 square feet?

At 10 ft² per roll with 5% waste, 100 ft² works out to 10.5 rolls before rounding. Round up when you total the whole yard.

How big is one roll of sod?

It depends on your supplier. The calculator starts at 10 ft² per roll, a 2 ft by 5 ft piece, and lets you change it. Check the listing before you order.

How much extra sod should I buy?

The calculator adds 5% for cuts. Yards with curves, corners or trees may need more, and a plain rectangle may need less. You can set it to any value.

Can I use the calculator for an odd-shaped yard?

Yes, by splitting the yard into rectangles and adding the areas. Type the combined area as the length and 1 as the width.

Does the count include topsoil, fertilizer or a roller?

No. The calculator counts sod rolls only. Ground preparation materials are separate.

Can the same calculator count grass seed?

Yes. Switch it to seed and enter the coverage printed on your seed bag. The guide on sod vs grass seed compares the two for the same lawn.

How Many Rolls of Sod Do You Need for a Yard?
Save or share this answer.

Sources and assumptions

These are the settings behind every number above. Verified figures link to a source. Editable defaults are common rules of thumb: change them in the calculator to match your product and your site.

SettingValueStatusSource
sod roll coverage10 ft2/rollEditable defaultCommon sod roll size (2 ft x 5 ft). Check what your supplier sells. Not verified.
seed bag coverage1,000 ft2/bagEditable defaultTypical grass seed bag coverage; varies by product. Check the label. Not verified.
sod waste5 percentEditable defaultContractor rule of thumb for cuts. Not verified.

Keep reading