Concrete & masonry
How Many Bags of Concrete Do You Need per Fence Post?
Quick answer: A 10 in round hole that is 3 ft deep takes 3 bags of 80 lb mix per post. For a 100 ft fence with 14 posts that comes to 42 bags of 80 lb mix (about 3 per post, with 10% extra). Wider and deeper holes use much more, so measure your own hole before you buy.
The answer depends on the hole, not on the fence. A post set in a 10 in hole that is 3 ft deep needs a different amount than one in a narrower or shallower hole. The numbers here come from the concrete columns and footings calculator and the fence calculator, and the example is a 100 ft run with 14 posts.
- Concrete mix, 80 lb bags42 bags
How many bags fill one post hole
Each hole is a cylinder. The table shows how many 80 lb bags fill one round hole completely (with 10% extra, rounded up), for a few common diameters and depths.
| Hole diameter | 2 ft deep | 3 ft deep | 4 ft deep |
|---|---|---|---|
| 6 in | 1 | 2 | 2 |
| 8 in | 2 | 2 | 3 |
| 10 in | 2 | 3 | 4 |
| 12 in | 3 | 5 | 6 |
The width matters more than most people expect. The area of a circle grows with the square of the diameter, so doubling the width of the hole quadruples the volume. A little extra width adds a lot of concrete.
The math, step by step
Use the same chain for any hole. The example is one 10 in round hole, 3 ft deep.
- Find the area of the hole. π × (diameter ÷ 2)², with the diameter in feet: π × (10 ÷ 24)² = 0.545 ft².
- Find the volume of one hole. Area × depth: 0.545 × 3 = 1.64 ft³.
- Multiply by the number of posts. 1.64 × 14 = 22.9 ft³.
- Add the waste allowance. 22.9 × 1.1 = 25.2 ft³.
- Divide by the yield of the bag and round up. An 80 lb bag yields about 0.6 ft³, so 25.2 ÷ 0.6 = 42, which is 42 bags.
Here is the volume of one hole at each diameter, 3 ft deep, before waste:
| Hole diameter | Area of the hole (ft²) | Volume at 3 ft deep (ft³) |
|---|---|---|
| 6 in | 0.2 | 0.59 |
| 8 in | 0.35 | 1.05 |
| 10 in | 0.55 | 1.64 |
| 12 in | 0.79 | 2.36 |
The yield comes from manufacturer data sheets (QUIKRETE lists about 0.6 ft³ for an 80 lb bag). Check the label on the bag you buy, because brands differ a little.
Bags for all the posts in a run
When you buy for a whole fence, the count is rounded up once for the full volume, not once per hole. For 10 in holes, 3 × 14 = 42 bags per hole against 42 for the run. For 12 in holes, 3 ft deep, one hole rounds up to 5 bags, so buying per hole would mean 70 bags, while the whole run needs 61. Here is the bag count for 14 posts at every combination of diameter and depth:
| Hole diameter | 2 ft deep | 3 ft deep | 4 ft deep |
|---|---|---|---|
| 6 in | 11 | 16 | 21 |
| 8 in | 18 | 27 | 36 |
| 10 in | 28 | 42 | 56 |
| 12 in | 41 | 61 | 81 |
Hole size versus the 2-bags-per-post rule of thumb
The fence calculator puts concrete on its shopping list with a flat rule: 2 bags of 80 lb mix per post, times the number of posts. It does not ask for the hole size and adds no waste. The rule is an unverified rule of thumb, and the calculator's own note says the right amount depends on the hole.
The geometry shows why the two answers differ. 2 bags at about 0.6 ft³ each give 1.2 ft³ per post. One 10 in hole, 3 ft deep, holds 1.64 ft³ before waste. For the 100 ft run with 14 posts, the rule gives 28 bags and the 10 in by 3 ft holes give 42 bags. Use the rule for a first guess and the hole size for the order.
| Fence run | Posts | Bags for 10 in x 3 ft holes | Bags by the rule of thumb |
|---|---|---|---|
| 50 ft | 8 | 24 | 16 |
| 100 ft | 14 | 42 | 28 |
| 150 ft | 20 | 60 | 40 |
| 200 ft | 26 | 78 | 52 |
If your post holes come out wider than planned, trust the geometry. This guide does not tell you how deep or wide to dig: check local code and the instructions for your posts, then enter your own size.
How gates and post spacing change the count
Posts are the multiplier, so anything that adds posts adds bags. The fence calculator takes each gate opening out of the fenced length, then counts posts as sections + 1 + gates, because each gate splits the line into separate runs with an end post on both sides. A shorter fenced length can drop a section, so one gate does not always add a post. Gate posts carry a swinging load, so if you dig those holes bigger, count them separately.
| Gates in the 100 ft run | Posts | Bags for 10 in x 3 ft holes |
|---|---|---|
| 0 | 14 | 42 |
| 1 | 14 | 42 |
| 2 | 15 | 45 |
Post spacing works the same way. Closer posts mean more holes:
| Post spacing | Posts | Bags for 10 in x 3 ft holes |
|---|---|---|
| 6 ft | 18 | 54 |
| 8 ft | 14 | 42 |
| 10 ft | 11 | 33 |
To count posts and pickets for a run, see how many fence posts and pickets for 100 feet.
Which bag size to buy
The 42 bags above are 80 lb bags. Smaller bags hold less mix, so the volume you need stays the same and only the count changes.
| Bag size | Yield per bag | Bags for 14 holes | Total weight bought |
|---|---|---|---|
| 80 lb | 0.6 ft³ | 42 | 3,360 lb |
| 60 lb | 0.45 ft³ | 56 | 3,360 lb |
| 40 lb | 0.3 ft³ | 84 | 3,360 lb |
The total weight is the same in each row, so the choice is about handling: fewer trips with 80 lb bags, lighter lifts with 60 lb or 40 lb bags. For the same yield per size in a slab, see how many bags of concrete for a 10x10 slab.
Round holes, square holes and ready-mix
Everything above assumes a round hole from an auger. A square hole dug with a shovel has more area for the same width. With 14 square 10 in holes, 3 ft deep, you would need 54 bags instead of 42.
For 14 holes, ready-mix would be 1 yd³, rounded up to the calculator's assumed 0.25 yd³ ordering step. A truck usually makes sense only above about 1 yd³, and many suppliers have a minimum order or a short-load fee, so ask before you order. Converting a volume to bags, or the other way, is covered in cubic yards of concrete to bags.
Common mistakes
- Using one bag count for every post. Gate posts, corner posts and holes that came out wide need their own count.
- Forgetting that width counts twice. A hole a few inches wider than planned can add a bag or more per post.
- Buying the exact number. With no margin one short bag stops the job. Add the waste allowance and round up.
- Ignoring the post itself. The post takes up room in the hole, so the figures lean a little high. That is a safe error, and it covers spills and holes that came out uneven.
- Skipping the label. Setting time, water amount and how much to fill the hole differ by product. Follow the bag you buy and your local code.
- Counting bags without counting posts. Get the post count first. The 100 ft run uses 14 posts with the default 8 ft spacing, not one per section.
Frequently asked questions
How many bags of concrete for one fence post?
For a 10 in hole that is 3 ft deep, buy 3 bags of 80 lb mix per post. A smaller hole needs fewer. See the first table for other sizes.
How many bags of concrete for a 100 ft fence?
A 100 ft fence with 14 posts needs 42 bags of 80 lb mix for 10 in by 3 ft holes. The 2-bags-per-post rule of thumb in the fence calculator would give 28 bags.
How much concrete is in one 80 lb bag?
About 0.6 ft³, based on manufacturer data sheets. The 60 lb bag yields about 0.45 ft³ and the 40 lb bag about 0.3 ft³.
How many bags do I need for 10 posts?
At 10 in by 3 ft, 30 bags of 80 lb mix cover 10 posts with 10% extra. Enter your own post count in the calculator above.
Do I fill the whole hole with concrete?
It depends on the product and the fence. Some installers fill the hole to the top, others leave room for soil. Read the bag and check local code. The figures here are for a full hole, so they are a safe upper bound.
Can I use ready-mix for fence posts?
For 14 holes you would order 1 yd³. That is not above the 1 yd³ where a truck usually pays off, so bags are normally easier. Ask your supplier about minimums.
How deep should a fence post hole be?
It depends on the fence height, the soil and the frost line in your area. This guide does not give a rule. Check local code, then enter your depth in the calculator.

Sources and assumptions
These are the settings behind every number above. Verified figures link to a source. Editable defaults are common rules of thumb: change them in the calculator to match your product and your site.
| Setting | Value | Status | Source |
|---|---|---|---|
| concrete bag yield 80lb | 0.6 ft3 | Verified 2026-11-13 | QUIKRETE data sheets list about 0.60 cubic feet per 80 lb bag (for example the Crack Resistant Concrete Mix 1006-80). Yield varies a little by product and by how wet… |
| concrete bag yield 60lb | 0.45 ft3 | Verified 2026-11-13 | QUIKRETE 5000 High Early Strength data sheet: a 60 lb bag yields about 0.45 cubic feet. Yield varies a little by product. |
| concrete bag yield 40lb | 0.3 ft3 | Verified 2026-11-13 | QUIKRETE Concrete Mix 1101 data sheet: a 40 lb bag yields approximately 0.30 cubic feet (8.5 L). Yield varies a little with water content. |
| readymix order increment | 0.25 yd3 | Editable default | Assumed ordering step for ready-mix; real minimums vary by supplier. Rule of thumb, not verified. |
| concrete readymix threshold | 1 yd3 | Editable default | Above about 1 cubic yard, ready-mix delivery is usually more practical than bags. Rule of thumb, not verified. |
| column waste | 10 percent | Editable default | Contractor rule of thumb for spillage and uneven holes. Not verified. |
Keep reading
- How Many Fence Posts and Pickets Do You Need for 100 Feet?A 100 ft picket fence with 8 ft spacing needs 14 posts, 220 pickets and 26 rails. See the formula and tables…
- How Many Bags of Concrete Do You Need for a 10x10 Slab?A 4-inch 10x10 slab needs 62 bags of 80 lb concrete with waste. See 60 lb and 40 lb counts, a thickness…
- How Many Bags of Concrete Do You Need for a 4x4 post?A 10 inch hole 2 ft deep for a 4x4 fence or deck post takes 2 bags of 80 lb concrete or 3 of 60 lb, with 10%…
- How Many Bags of Concrete Do You Need for a 6x6 post?A 12 inch hole 3 ft deep for a 6x6 post for a pergola, deck or carport takes 5 bags of 80 lb concrete or 6…
- How Many Bags of Concrete Do You Need for a Mailbox post?An 8 inch hole 2 ft deep for a mailbox post takes 2 bags of 80 lb concrete or 2 of 60 lb, with 10% extra…
- How Many Bags of Concrete Do You Need for a Basketball hoop?An 18 inch hole 4 ft deep for an in-ground basketball hoop takes 13 bags of 80 lb concrete or 18 of 60 lb…
- How Many Bags of Concrete Do You Need for an 8 inch sonotube?An 8 inch hole 4 ft deep for an 8 inch tube form takes 3 bags of 80 lb concrete or 4 of 60 lb, with 10%…
- How Many Bags of Concrete Do You Need for a 10 inch sonotube?A 10 inch hole 4 ft deep for a 10 inch tube form takes 4 bags of 80 lb concrete or 6 of 60 lb, with 10%…